1-805-484-2992
Quotes - Engineering - SalesAT510
Mueller| Product | Style | Ratings | Configuration |
|---|---|---|---|
| Heat Exchanger | Plate & Frame | 350 PSI / 410°F | B Frame |
Download Datasheet
Note: the unit pictured is representative of the standard build and may not exactly depict p/n AT510 as shown on this page.
AT510 specifications
Description
Cataloged as AT510, this Accu-Therm plate heat exchanger uses 90" tall by 30" wide pressed plates and 6" ports. The gasketed plate pack ranges from 34-5/8" - 160-5/8" in length, delivering approximately 200 - 4,400 sq ft of surface, and it unbolts for inspection and cleaning without cutting pipe. Per-plate surface runs near 6.8 square feet, and the unit handles water flows to about 1800 GPM. Plates are available in 304 or 316 stainless, titanium, and higher alloys; gaskets in NBR, EPDM, and high-temperature EPDM using Loc-In attachment. Frame options include B Frame - for larger units, plates hang from the upper guide bar; capacity to 900 plates. Typical duty is water-to-water HVAC, process cooling, heat recovery, and food and beverage service.
Product Overview
Part Number:
AT510
Series:
Accu-Therm
Brand:
Mueller
Codes & Compliance:
ASME Sec VIII Div 1, CRN, DNV
Also Written:
AT 510, AT-510
Configuration & Size
Surface Area (Sq/Ft):
200 - 4,400 sq ft
Connection Type:
Studded port standard; lap-joint, weld-neck, ferrule, Victaulic
Frame Type:
B | B Frame (Beam)
Max Plate Count:
650 (est.)
Mounting:
Floor mounted frame
Passes:
Single pass standard; multi-pass available
Plate Height:
90"
Plate Pack Length Range:
34-5/8" - 160-5/8"
Plate Pattern:
Chevron H / V / combination (510M)
Plate Thickness:
0.5 mm standard
Plate Width:
30"
Port Size:
6"
Wall Construction:
Single wall gasketed
Heat Transfer Area per Plate (Sq/Ft):
6.8 (est.)
Max Flow Rate (GPM):
1800
Performance Rating:
U-value 1,500 BTU/hr-ft²-°F and greater
Performance Rating (Basis):
Clean water-to-water service; 1°F to 3°F approach. Actual duty depends on plate count, pattern, and fluid properties.
Materials of Construction
- Frame: Painted carbon steel; stainless optional. Zinc-plated compression bolts
- Gasket: NBR or EPDM standard; High-Temp EPDM, Viton/FKM, Butyl. FDA/3-A
- Gasket Attachment: Loc-In
- Plate: 316 SS standard; 304 SS, Titanium, Hastelloy C-276, SMO 254 optional
Rating
- Max Temperature: 410°F design; 302°F - 329°F gasket limit
- Max Working Pressure: 350 PSI design
- Min Temperature: -20°F (MDMT 32°F typical)
- Test Pressure: 1.3 x MAWP
